Programming and Relearning

Electronic Brake Control Module Programming and Setup

EBCM Replacement

If the electronic brake control module (EBCM) is replaced, the following procedures must be performed:

* EBCM Reprogramming-Refer to Service Programming System (SPS) (Service Programming System (SPS)).
* Revise the yaw rate sensor recalibration using the Scan Tool yaw rate recalibration function.
* Revise the tire calibration using the Scan Tool Tire Size calibration function.

Yaw Rate Sensor/Lateral Accelerometer Replacement

If the yaw rate sensor/lateral accelerometer is replaced, the following procedures must be performed:

* Revise the yaw rate sensor recalibration using the Scan Tool yaw rate recalibration function.
* Revise the tire calibration using the Scan Tool Tire Size calibration function.