RECIRCULATION Control Motor
WARNING: This page is about a different car, the 1999 Acura 3.0CL and 1999 Acura 2.3CL. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect recirculation control motor 4-pin connector. Connect battery voltage to recirculation control motor terminal No. 1 and ground terminals No. 2 and 4. See Fig 1 . If recirculation control motor runs smoothly, go to step 3 .
- If recirculation control motor does not run, check recirculation control motor doors and linkage for smooth operation. If doors and linkage are okay, replace recirculation control motor.
- Disconnect terminals No. 2 and 4 from ground. If recirculation control motor does not stop at fresh or recirculate position, replace recirculation control motor. If recirculation control motor stops at fresh or recirculate position, motor is okay.