LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2002 >> MDX Base, BGHA >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Multiplex Control Systems >> System Tests >> Communication Lines >> Door-To-Driver's Multiplex Control Unit
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Door-To-Driver's Multiplex Control Unit

  1. Turn ignition off. Check continuity in communication line (Brown wire) between door multiplex control unit harness connector terminal A15 and driver's multiplex control unit harness connector terminal A2. See WIRING DIAGRAMS  . If continuity exists, go to next step. If continuity does not exist, repair open in Brown wire. After repairs, recheck DTCs.
  2. Turn ignition on. Check voltage in communication line (Brown wire) between ground and door multiplex control unit harness connector terminal A15, and driver's multiplex control unit harness connector terminal A2. Voltage should be 3.5-9.5 volts at both terminals. If voltage is not as specified, go to next step.
  3. If voltage is greater than 9.5 volts, check for short in circuit or poor contact or faulty circuit at connector on receiver side of unit. If voltage is less than 3.5 volts, check for short to ground or short to another wire in circuit. Check for poor contact or faulty circuit at connector on transmitter side unit. Repair as necessary. After repairs, recheck DTCs.
scientia non olet · About LEMON Manuals