LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2004 >> TSX Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Navigation System) >> System Description >> Display Unit Inputs and Outputs for 20P Connector
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Display Unit Inputs and Outputs for 20P Connector

WARNING: This page is about a different car, the 2008 Acura TSX, 2007 Acura TSX, and 2006 Acura TSX. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Display Unit Inputs And Outputs 20P Connector
G05489403Courtesy of AMERICAN HONDA MOTOR CO., INC.
DISPLAY UNIT INPUTS AND OUTPUTS FOR 20P CONNECTOR

Terminal Number Wire Color Terminal Name Description Voltage (about) Symptom
1 RED +B (+B power source) Continuous power source Battery voltage If open: Screen completely off (no backlight visible).
If short to ground: Blows fuse No. 7 (10 A) in the under-dash fuse/relay box.
2 YEL ACC (Accessory) Power source for accessory Battery voltage at ACC (I) If open: Display and buttons do not work.
If short to ground: Blows fuse No. 32 (7.5 A) in the under-dash fuse/relay box.
3 GRN AUD BUS (+) (Audio bus positive) Data bus (+) GA-Net 0-5 V pulses average 2.5 V depends on bus traffic If open: Navigation buttons and touch screen do not work.
If short to ground: Navigation buttons and touch screen do not work.
4 GRY SH AUD BUS (Shield audio bus) Shield for audio bus terminal No. 3, 13 0 V If open: No change to display.
If short to ground: No change to display
5 BLU DISP BUS (+) (Display bus positive) Data bus (+) GA-Net 0-5 V pulses average 2.5 V depends on bus traffic If open: Navigation buttons and touch screen do not work.
If short to ground: Navigation buttons and touch screen do not work.
8 WHT R SIG (Red signal) Red color signal 0.2 VAC average in RGB color diagnostic mode If open: Red color missing (see "RGB COLOR " diagnostic).
If short to ground: Red color missing (see "RGB COLOR " diagnostic).
9 RED G SIG (Green signal) Green color signal 0.2 V AC average in RGB color diagnostic mode If open: Green color missing (see "RGB COLOR " diagnostic).
If short to ground: Green color missing (see "RGB COLOR " diagnostic).
10 BLK GND (Ground) Ground for display unit 0 V If open: No change to display.
If short to ground: No change to display.
13 RED AUD BUS (-) (Audio bus negative) Data bus (-) GA-Net 0-5 V pulses average 2.5 V depends on bus traffic If open: Navigation buttons and touch screen do not work.
If short to ground: Hard and touch buttons work OK.
14 GRY SH DISP BUS (Shield display bus) Shield for display bus terminal No. 5, 15 0 V If open: No change to display.
If short to ground: No change to display.
15 PNK DISP BUS (-) (Display bus negative) Data bus (-) GA-Net 0-5 V pulses average 2.5 V depends on bus traffic If open: Navigation buttons and touch screen do not work.
If short to ground: Hard and touch buttons work OK.
17 BLK GND SIG (Ground signal) Ground for color signal 0 V If open: No change to display.
If short to ground: No change to display.
18 YEL B SIG (Blue signal) Blue color signal 0.2 V AC average in RGB color diagnostic mode If open: Blue color missing (see "RGB COLOR " diagnostic).
If short to ground: Blue color missing (see "RGB COLOR " diagnostic).
19 GRN C SIG (Composite signal) Composite video (vertical/horizontal) synchronizing signal 0.2 VAC average in RGB color diagnostic mode If open: Picture rolls horizontally, colors still visible.
If short to ground: Picture rolls horizontally, colors still visible.
20 GRY SH SIG (Shield signal) Shield for terminal No. 8, 9, 17, 18, 19 0 V If open: No change to display.
If short to ground: No change to display.