Climate Control Switch Assembly Removal/Installation

WARNING: This page is about a different car, the 2008 Acura TL and 2007 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.

Remove the audio-HVAC display module assembly (see AUDIO-HVAC DISPLAY MODULE ASSEMBLY REMOVAL/INSTALLATION ).
Remove the self-tapping screws and the audio unit (A) and bracket (B) from the display panel control unit (C).

Fig 1: Identifying Audio Unit, Bracket And Display Panel Control Unit
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect 10P connector (A) and 16P connector (B) from the display panel control unit (C). Remove the self-tapping screws and the climate control switch assemblies (D).

Fig 2: Identifying 10P Connector, 16P Connector, Display Panel Control Unit And Climate Control Switch Assemblies
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the control switch assembly in the reverse order of removal. After installation, operate the control switch assembly controls to see if they work properly.
Run the self-diagnostic function to confirm that there are no problems in the system (see HOW TO RETRIEVE A DTC (WITHOUT HDS) ).