Cruise Control Combination Switch Test/Replacement

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) in the SRS before doing repairs or service.

1. Remove the driver's airbag (see DRIVER'S AIRBAG REPLACEMENT ).
2. Remove the steering wheel (see STEERING WHEEL REMOVAL ).
3. Remove the six screws, then remove the cruise control combination switch.
   Fig 1: Identifying Cruise Control Combination Switch Connector Terminal

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Check for continuity between the terminals in each switch position according to Fig 2.
   • If there is continuity, and it matches the table, but-switch failure occurred on the cruise control input test, check and repair the wire harness on the switch circuit.
   • If there is no continuity in one or both positions, replace the switch.
     Fig 2: Checking For Continuity Between Terminals In Each Switch Position

     Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. Check for continuity between the terminals in according to Fig 3.
   • If there is continuity, and it matches the table, check and repair the wire harness on the switch circuit.
   • If there is no continuity in one or more positions, replace the switch.
     Fig 3: Checking For Continuity Between Terminals

     Courtesy of AMERICAN HONDA MOTOR CO., INC.