LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2007 >> RL >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Wiper System & Washer System) >> Wiper/Washer Switch Test/ Replacement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Wiper/Washer Switch Test/ Replacement

WARNING: This page is about a different car, the 2008 Acura TL and 2007 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The wiper/washer switch is built into the combination switch control unit. For the wiper/washer test, refer to the combination switch control unit input test (see WIPER/WASHER SWITCH (COMBINATION SWITCH CONTROL UNIT) INPUT TEST  ).
  1. Remove the dashboard lower cover (see DRIVER'S DASHBOARD LOWER COVER REMOVAL/INSTALLATION ).
  2. Remove the steering column covers (see STEERING COLUMN REMOVAL AND INSTALLATION ).
  3. Disconnect the dashboard wire harness 8P connector (A) from the wiper/washer switch (B), and the combination light switch 12P connector (C).
    Fig 1: Identifying Dashboard Wire Harness 8P Connector And Wiper/Washer Switch
    G05462772Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the two screws, then slide out the wiper/washer switch.
scientia non olet · About LEMON Manuals