DTC B1060: Relay Control Module Lost Communication with Gauge Control Module (VPS/NE Message); DTC B1061: Relay Control Module Lost Communication with Gauge Control Module (A/T Message)
NOTE:
If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see
TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A
).
- Clear the DTCs with the HDS.
- Turn the ignition switch to LOCK (0), and then back ON (II).
- Wait for 6 seconds or more.
- Check for DTCs with the HDS.
Is DTC B1060 and/or B1061 indicated?
YES - Go to step 5.
NO - Intermittent failure, the system is OK at this time. Check for loose or poor connections between the relay control module and the gauge control module.
- Check for DTCs with the HDS.
Are DTCs B1011, B1032, B1060, B1061, B1205, B1206, B1207, B1906, B1956, B2157, and B2160 all indicated?
YES - Do the gauge control module input test (see GAUGE CONTROL MODULE INPUT TEST ).
NO - Do the relay control module input test (see RELAY CONTROL MODULE INPUT TEST ).