Immobilizer Control Unit-Receiver Replacement
- Remove the driver's dashboard undercover (see
DRIVER'S DASHBOARD UNDERCOVER REMOVAL/INSTALLATION
), and the driver's dashboard lower cover (see
DRIVER'S DASHBOARD LOWER COVER REMOVAL/INSTALLATION
).
- Remove the steering column covers (see
STEERING COLUMN REMOVAL AND INSTALLATION
).
- Remove the ignition switch knob (A).
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Disconnect the 7P connector (B) from the immobilizer control unit-receiver (C).
- Remove the two screws and the immobilizer control unit-receiver from the ignition key cylinder (D).
- Install the immobilizer control unit-receiver in the reverse order of removal.
- After replacement, the immobilizer control unit-receiver must be registered in IMMOBILIZER with the HDS (all keys and the PCM code are required).