LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2009 >> CSX Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Power Window System) >> Rear Power Window Motor Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Rear Power Window Motor Test

WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear door panel (see REAR DOOR PANEL REMOVAL/INSTALLATION )
  2. Test the rear power window motor in each direction by connecting battery power and ground to the rear power window switch 14P connector (A) according to the table
    Fig 1: Rear Power Window Motor Terminals Chart
    G05989018Courtesy of AMERICAN HONDA MOTOR CO., INC.
    Fig 2: Identifying Rear Power Window Switch 14P Connector Terminals
    G05989019Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. If the motor does not run or fails to run smoothly, go to step 4
  4. Disconnect the 2P connector (A) from the rear power window motor (B)
    Fig 3: Identifying Rear Power Window Motor And 2P Connector
    G05989020Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Check for continuity between rear power window switch 14P connector terminals No 1 and No 7, and rear power window motor 2P connector terminals No 1 and No 2 respectively There should be continuity

    REAR POWER WINDOW SWITCH 14P CONNECTOR 

    Terminal No 1

    Terminal No 7

    REAR POWER WINDOW MOTOR 2P CONNECTOR 

    Terminal No 1

    Terminal No 2

    Fig 4: Checking Continuity Between Rear Power Window Switch 14P And Rear Power Window Motor 2P Connector Terminals
    G05989021Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. If there is no continuity, repair open in the wires If the wire harness is OK, replace the rear power window motor
scientia non olet · About LEMON Manuals