LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2009 >> CSX Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Electronic Throttle Control System) >> Accelerator Pedal Module Removal and Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Accelerator Pedal Module Removal and Installation: Removal

WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the driver's dashboard undercover (see DRIVER'S DASHBOARD UNDERCOVER REMOVAL/INSTALLATION )
  2. Disconnect the APP sensor 6P connector (A)
    Fig 1: Identifying APP Sensor 6P Connector, Mounting Nuts, Clip And Pedal Stop
    G05987526Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the two mounting nuts (B), then remove the clip (C) Using a flat-tip screwdriver (D), push the lock (E), then remove the accelerator pedal pad (F) from the pedal stop (G)
  4. Remove the accelerator pedal module
    NOTE:
    • The APP sensor is not available separately Do not disassemble the accelerator pedal module
    • If the pedal stop is damaged, replace it by pulling back the carpet (A), and removing the nuts (B), the bolt (C), and the pedal stop (D)
      • Fig 2: Carpet, Nuts, Bolt And Pedal Stop With Torque Specification
      G05987527Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals