Power Mirror Switch Test/Replacement

WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.

Remove the driver's door panel (see FRONT DOOR PANEL REMOVAL/INSTALLATION )
Remove the screws from the driver's door grip (A) and grip cover (B)

Fig 1: Identifying Driver's Door Grip, Grip Cover Power Mirror Switch And 13P Connector With Screws
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Pull out the grip cover slightly from the door grip, then disconnect the 13P connector (C) from the power mirror switch (D)
Remove the two screws and the power mirror switch (A) from the grip trim (B)

Fig 2: Identifying Power Mirror Switch, Grip Trim And Connector Terminals With Screws
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between the terminals in each switch position according to the table
Power mirror switch

Fig 3: Terminal Continuity Reference Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the continuity is not as specified, replace the power mirror switch
Install the switch in the reverse order of removal