Tailgate Outer Handle Switch Test/Replacement

Remove the tailgate trim panel (see TRIM REMOVAL/INSTALLATION - TAILGATE AREA ).
Disconnect the 3P connector (A) from the tailgate outer handle switch (B).

Fig 1: Locating 3P Connector And Tailgate Outer Handle Switch
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between tailgate outer handle switch 3P connector terminals No. 2 and No. 3.
- There should be continuity when the tailgate outer handle is pulled.
- There should be no continuity when the tailgate outer handle is released.
If the continuity is not as specified, remove the two bolts and replace the tailgate outer handle switch (A).

Fig 2: Locating Bolts And Tailgate Outer Handle Switch
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the switch in the reverse order of removal.