Motor Test

NOTE: SRS components are located in this area Review the SRS component locations (see COMPONENT LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or service.

Remove the front seat-back cover, and seat-back cover/pad (see FRONT SEAT-BACK COVER REPLACEMENT )
Disconnect the 2P connector (A) from the lumbar support motor (B)

Fig 1: Identifying Lumbar Support Motor And 2P Connector Terminals
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Test the motor by applying battery power and body ground to the terminals

Fig 2: Terminal Continuity Reference Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the motor does not run or fails to run smoothly, replace it (see FRONT SEAT LUMBAR SUPPORT REPLACEMENT )