LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2011 >> TL Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> Input Shaft (Mainshaft) Speed Sensor Replacement
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Input Shaft (Mainshaft) Speed Sensor Replacement

  1. Do the battery removal procedure (see BATTERY REMOVAL AND INSTALLATION )
  2. Disconnect the input shaft (mainshaft) speed sensor connector, and remove the input shaft (mainshaft) speed sensor (A)
    Fig 1: Input Shaft (Mainshaft) Speed Sensor And O-Ring With Torque Specification
    G05990784Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Install a new O-ring (B) on a new input shaft (mainshaft) speed sensor, then install the input shaft (mainshaft) speed sensor
  4. Check the connector for rust, dirt, or oil, then connect the connector securely
  5. Do the battery installation procedure (see BATTERY REMOVAL AND INSTALLATION )
scientia non olet · About LEMON Manuals