Line Pressure Switch Replacement

WARNING: This page is about a different variant/trim than selected.

Do the battery removal procedure (see BATTERY REMOVAL AND INSTALLATION ).
Remove the battery base (see ENGINE REMOVAL ).
Disconnect the line pressure switch connector, and remove the line pressure switch (A) and the sealing washer (B).

Fig 1: Line Pressure Switch And Sealing Washer With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install a new line pressure switch with a new sealing washer, and tighten the switch.
Check the connector for corrosion, dirt, or oil, and clean or repair if necessary, then connect the connector securely.
Install the battery base (see ENGINE INSTALLATION ).
Do the battery installation procedure (see BATTERY REMOVAL AND INSTALLATION ).