LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2016 >> RLX Base >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System / Engine Mechanical - Service, Testing & Troubleshooting (Except Hybrid) >> General Information >> How to Set Readiness Codes >> EGR Monitor and Readiness Code
April 5, 2026: LEMON Manuals is launched! Read the announcement.

EGR Monitor and Readiness Code

NOTE:
  • During the procedure, do not turn the vehicle to the ACCESSORY mode or the OFF (LOCK) mode.
  • All readiness codes are cleared when the battery is disconnected, if DTCs have been cleared, or if the PCM is reset with the HDS.

Enable Criteria 

ECT SENSOR 1 at 176 deg.F (80 deg.C) or more.

Procedure 

1. Connect the HDS to the DLC.

2. Start the engine.

3. Drive at a steady speed with the transmission in D at 50-62 mph (80-100 km/h) or above for more than 10 seconds.

4. With the transmission in D, decelerate from 62 mph (100 km/h) or above by completely releasing the throttle for at least 5 seconds. If the engine is stopped during this step, repeat steps 3 and 4.

5. Check the OBD status screen for DTC P0401 in the DTC's MENU with the HDS.

scientia non olet · About LEMON Manuals