Before Aiming Setting (Static Camera Aiming): Adjustment: Notes
How to use this service information .
Precautions before aiming setting:
Set up the vehicle:
- Make sure the suspension has not been modified.
- Make sure all tire sizes are correct and that their pressures are correct.
- Make sure the steering wheel is pointed straight ahead, and do not turn it after setting the vehicle.
- Remove all cargo from the vehicle except the tool kit and the spare tire (if equipped).
- Shift the transmission to P position/mode (CVT) or neutral position (M/T), and apply the parking brake.
- Make sure that all doors are closed.
Conditions for the aiming environment:
- Aiming should be done in a well-lighted area.
- There should be no bright objects at the back of the target (sunlight, windows, illumination, or reflectors) or designs similar to the target pattern.
- When the multipurpose camera is adjusted on a floor surface that are not flat floor (drainage slope etc.), the camera aiming cannot be adjusted correctly, check the levelness of the floor surface.
- If oil drips on the floor, wipe it off.
Prepare these items:
- Tape measure and ruler
- Felt-tip pen
- Tape
- String (A laser cross liner can be used as an alternative)
- Plumb bob
NOTE:
When marking on the floor surface, use suitable tape to mark the exact locations.