CSS_5V, CSS_SIG2, CSS_GND Circuit Inspection

Test Procedure 

• Preparation
• • -

    VSA modulator-control unit connector (46P): disconnected

  • -

    Clutch pedal stroke sensor connector (4P): disconnected

• Procedure
• • -

    Perform the inspection according to the following table.

(Disconnected)VSA modulator-control unit connector (46P) female terminals

(Disconnected)Clutch pedal stroke sensor connector (4P)female terminals

IG Mode

Courtesy of HONDA, U.S.A., INC.

Courtesy of HONDA, U.S.A., INC.

Normal Conditions

CSS_5V open wire inspection 

OFF

There is less than 1 Ohm 

CSS_SIG2 open wire inspection 

OFF

There is less than 1 Ohm 

CSS_GND open wire inspection 

OFF

There is less than 1 Ohm 

Refer to the Open/Shorted Wire Inspection Description for the method to inspect the shorted circuit below, then start to inspect according to circumstances.

CSS_5V shorted to ground inspection 

OFF

There is more than 1 MOhm 

CSS_SIG2 shorted to ground inspection 

OFF

There is more than 1 MOhm 

CSS_GND shorted to power inspection 

ON

Not shorted 

Results 

• If abnormal, there is a problem in the circuit.