Diagnostic Test

TORQUE VECTORING MODULE VERIFICATION TEST 

1. Disconnect all jumper wires and reconnect all previously disconnected components and connectors.
2. With the scan tool, erase Torque Vectoring Module (TVM) DTCs.
3. Make sure that all accessories are turned off and that the battery is fully charged.
4. Test drive the vehicle and verify proper operation.
5. With the scan tool, read TVM DTCs.

   Are there any DTCs present in the TVM module?

   Yes 

   • Refer to DIAGNOSIS AND TESTING  and perform the appropriate diagnostic procedure.

   No 

   • Repair is complete.