LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Audi >> 1994 >> S4 >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls - Self-Diagnostics >> Output Diagnostic Test Mode (DTM) >> Reading/Measuring Value Block (Function 08) >> Display Group 01-09
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Display Group 01-09

NOTE: For help in identifying Display Group Number Breakdown and Display Group Number Overview information charts (tables), refer to illustrations. See Figure -Figure
  1. Press the -C- button each time a new display group is required.
  2. If the -right arrow- button is pushed or the -C- button is accidentally pressed twice, "Read Measuring Value Block" function 08 must be re-selected.
  3. Clarification and additional information for individual displays or data (for the specified values) can be found in SYSTEM & COMPONENT TESTING article.
  4. The displays described in display groups 01 to 05 and display group 07 are not all used.
  5. Display group 01 selection has been shown as an example. Select the other display groups in the same way.
  6. Press buttons -0- and -1- to select display group 01. Display will read - "READ MEASURING VALUE BLOCK" "INSERT DISPLAY GROUP NUMBER 01".
  7. Press -Q- button to confirm input. Display will read - "READ MEASURING VALUE BLOCK" "1 2 3 4".
    NOTE: When display groups 00 through 09 are displayed with "Read measuring value block," the zeroes in the display group designations are omitted from the display. Display group 00 is not shown. Display groups 01 through 09 are shown as single numbers 1, 2, 3, etc.
scientia non olet · About LEMON Manuals