O-Rings, Seals, Gaskets
- Always replace O-rings, seals and gaskets.
- After removing O-rings, check contact surface on housing or shaft for removal dependent burrs or damage.
- Coat O-rings with ATF at outside circumference and at sealing lip for installation.
- Coat O-rings with ATF or Vaseline when installing , to prevent pinching of the rings during installation.
- Do not use any other lubricants in ATF area. Otherwise malfunctions of the hydraulic transmission control may occur.
- The open side of the oil seals faces the fluid to be sealed in.
- Check and if necessary top up transmission oil or ATF fluid after installing.