Digital Sound System Control Module -J525-, REMOVING AND INSTALLING, BANG & OLUFSEN, FROM MY 2015: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2018 Audi A7 Quattro, 2017 Audi S7, and 2017 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical consumers and remove the ignition key.

-- Remove the left luggage compartment side trim panel. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING .

The bracket with the Digital Sound System Control Module -J525- must be removed first.

-- If equipped, remove the trailer hitch lever. Refer to IMPACT MEMBER, REMOVING AND INSTALLING, VEHICLES WITH TRAILER HITCH .

-- Remove the nuts - 4, 6 and 7- and the screw - 2- on the bracket - 1-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the brace - 3-.

-- Pivot the Digital Sound System Control Module -J525- - 5- with the bracket - 1- into the luggage compartment.

-- Release and disconnect the connectors from the Digital Sound System Control Module -J525- - 5-.

Courtesy of AUDI OF AMERICA, LLC

-- If equipped, release and disconnect the connectors from the TV Tuner -R78-.

-- Insert the : VAS6223/9 -1- onto the MOST bus connector -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Digital Sound System Control Module -J525- -5- with the bracket -1-.

It is not necessary to remove the TV Tuner -R78-.

-- Remove the screws -arrows- and remove the Digital Sound System Control Module -J525- -1- from the bracket -2-.

Courtesy of AUDI OF AMERICA, LLC