Engine Mount

WARNING: This page is about a different car, the 2014 Audi A8 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Subframe Mount Assembly Overview

Courtesy of AUDI OF AMERICA, LLC

Bolt
- 20 Nm
Retaining Plate
- For the engine mount
- If the engine mount is faulty, replace the retaining plate
- Check the retaining plate on the opposite side; replace if necessary
Bolt
- 40 Nm
Engine Support
Bolt
- 10 Nm
Heat Shield
Bolt
- 90 Nm + an additional 90° turn
- Replace
Engine Mount
- Left with the Left Electrohydraulic Engine Mount Solenoid Valve -N144-
- Right with the Right Electrohydraulic Engine Mount Solenoid Valve -N145-
- Removing and installing, refer to ENGINE MOUNT, REMOVING AND INSTALLING .
- Replace in pairs
Subframe
Bolt
- 55 Nm

Fig 2: Identifying Hydraulic Oil Hose Bracket & Nut

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the nut -2- for the hydraulic hose bracket -1- to 9 Nm.