External Multimedia Device Interface, Removing And Installing: Removing:

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

-- If the control module is replaced, select the "Replacement" function for the appropriate control module in "Guided Fault Finding".

Connect the Vehicle Diagnostic Tester to do this.

Perform the Following Steps:

-- Turn off the ignition and all electrical equipment.

-- Open the glove compartment and pull the lever in the direction of -arrow A-. This lowers the installation frame with the external multimedia device interface in the direction of -arrow-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Insert the Radio Removal Tool:T10057 into the openings -arrows- until it locks into place.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Push the tool in direction -A- and remove the control module in the direction of -arrow B-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the connector -A- from the control module -arrow-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.