DTC Memory With ODIS, Checking

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Warning information for the high voltage system:

Procedures for which the ignition needs to be switched on. Refer to PROCEDURES FOR WHICH THE IGNITION NEEDS TO BE SWITCHED ON .

-- Connect the Vehicle diagnostic tester. Refer to Vehicle Diagnostic Tester, CONNECTING .

-- Select Diagnosis operating mode and start diagnosis.

-- Select the VIN.

-- Set V and press Accept to select "Work with guided fault finding".

-- Continue following the program procedure.

NOTE:

The following describes the control module identification and forwarding to the guided fault finding.

-- Select the Control modules tab.

-- Select control modules and the Check DTC memory function by right clicking on it to see faults stored in the DTC memory.

-- Continue following the program procedure.

-- Rectify the relevant errors after discussing them with the customer.