Monitor-Id $01: Catalytic Conversion (Bank 2)
-- Connect the scan tool.
-- Start the engine and run at idle.
-- Select "Diagnostic Mode 06: Check / test the results of components that are not continuously monitored".
Select "Monitor-ID $01".
-- Select the desired "Test-ID".
-- Check specified values at idle.
| Test-ID | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| $06 | P0431 | Conversion Capability (Storage) Check. | 0.2031 | 0.8156 | Refer to DTC P0431 in the DTC summary table.Engine Control Module --, 2008 - 2012 MY |
| $07 | P0421 | Catalytic Converter Monitoring Sum Malfunction Bank 1 + Bank 2, Aging Value. | --- | 1.9766 | Refer to DTC P0421 in the DTC summary table.Engine Control Module --, 2008 - 2012 MY |
| $09 | P0431 | Conversion Capability (Storage) Check. | --- | 0.9883 | Refer to DTC P0431 in the DTC summary table.Engine Control Module --, 2008 - 2012 MY |
| 11 | --- | --- | 0.8156 | --- |
-- If any of the components or systems fail to meet the specified values, refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC's or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .
-- Switch the ignition off.