Sensor Electronics Control Module -J849-, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S6, 2015 Audi A6 Quattro, 2015 Audi A6, 2014 Audi S6, and 2014 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Excessive shaking will damage the Sensor Electronics Control Module -J849-.

-- Install in reverse order of removal.

-- Mount the Sensor Electronics Control Module -J849- on the four bolts.

NOTE: Make sure it is installed in the correct position The connector faces the direction of travel.

When installing the Sensor Electronics Control Module -J849- -2- make sure it is correctly seated in its mounting and is free of stress.

Fig 1: Identifying Sensor Electronics Control Module With Nuts

Courtesy of AUDI OF AMERICA, LLC

Push the Sensor Electronics Control Module -J849- into position without using the bolts or using force.

NOTE: To install the Sensor Electronics Control Module -J849- free of tension, install all the nuts loosely and then tighten them diagonally.

-- Install all four nuts -1-.

Fig 2: Identifying Sensor Electronics Control Module With Nuts

Courtesy of AUDI OF AMERICA, LLC

-- Tighten all four nuts -1- to 9 Nm.

-- Connect the connector -3-.

Start the program in Guided Functions on the Vehicle Diagnostic Tester if the control module is replaced.

-- Connect the Vehicle Diagnostic Tester to the vehicle data link connector with the ignition switched off.

NOTE:

Switch the ignition on.

DTC memory interrogated, errors shown corrected and DTC memory erased.

-- Start the program in Guided Functions.