Tightening Specifications
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S6, 2015 Audi A6 Quattro, 2015 Audi A6, 2014 Audi S6, and 2014 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
| Component | - | Nm |
|---|---|---|
| Four hydraulic unit brake lines to the brake calipers | 14 | |
| Hydraulic unit brake lines to master brake cylinder | 16 | |
-- Install the brake lines into the mounts.
-- Connect the connector to the coolant reservoir.
-- Install the coolant reservoir with attached coolant lines.
-- Fasted the coolant reservoir with attached coolant lines to the bracket.
-- Remove the Brake Pedal Actuator VAG 1869/2.
-- Refer to BRAKE SYSTEM, BLEEDING
-- Start the program in Guided Functions on the Vehicle Diagnostic Tester if the control module is replaced.
-- Perform an output diagnostic test in Guided Functions on the Vehicle Diagnostic Tester after attaching the brake lines.
CAUTION:
Make sure the brakes are working correctly before driving the vehicle.