Windshield Projection Head Up Display Control Module -J898-, CALIBRATING: Procedure

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S6, 2015 Audi A6 Quattro, 2015 Audi A6, 2014 Audi S6, and 2014 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Head-Up Display Calibration Board

Courtesy of AUDI OF AMERICA, LLC

-- Move the vehicle onto a secure flat surface.

-- Set the parking brake - the vehicle must not move during the measuring.

-- Fold down the left and right sun visors, disengage them and move them to the side.

-- Attach the Head-Up Display Calibration Board Audi A6 VAS 6657 calibration device to the center retainers -1 and 2- for the sun visors.

-- Use the Vehicle Diagnostic Tester in Guided Fault Finding. Select the function windshield projection head up display control module -J898-.

After selecting calibrate windshield projection control module, select the path height calibration.

-- Follow the instructions in the Vehicle Diagnostic Tester display.

-- After calibrating the windshield projection control module successfully, end calibration, turn off the ignition and disconnect the diagnostic connector.