Digital Sound System Control Module -J525-, REMOVING AND INSTALLING, BANG & OLUFSEN, FROM MY 2015: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S6, 2015 Audi A6 Quattro, 2015 Audi A6, 2014 Audi S6, and 2014 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical consumers and remove the ignition key.

-- Remove the left luggage compartment side trim panel. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL (Sedan) or LUGGAGE COMPARTMENT SIDE TRIM PANEL (Wagon) .

The bracket with the Digital Sound System Control Module -J525- must be removed first.

-- Remove the nuts -4, 6 and 7- and the screw -2- on the bracket -1-.

Fig 1: Locating Nuts -4, 6 And 7- And Screw -2- On Bracket -1-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the brace -3-.

-- Pivot the Digital Sound System Control Module -J525- -5- with the bracket -1- into the luggage compartment.

-- Release and disconnect the connectors from the Digital Sound System Control Module -J525- -5-.

Fig 2: Locating Nuts -4, 6 And 7- And Screw -2- On Bracket -1-

Courtesy of AUDI OF AMERICA, LLC

-- Insert the Fiber-Optic Repair Set - Connector Protective CapsVAS6223/9 -1- onto the MOST Bus connector -2-.

Fig 3: Identifying Fiber-Optic Cable Harness Connector And Protective Cap For Cable Connector VAS 6223/9

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Digital Sound System Control Module -J525- -5- with the bracket -1-.

-- Remove the screws -arrows- and remove the Digital Sound System Control Module -J525- -1- from the bracket -2-.

Fig 4: Removing Digital Sound System Control Module -J525- -1- From Bracket -2-

Courtesy of AUDI OF AMERICA, LLC