Digital Sound System Control Module -J525-, REMOVING AND INSTALLING, BANG & OLUFSEN, THROUGH MY 2014: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S6, 2015 Audi A6 Quattro, 2015 Audi A6, 2014 Audi S6, and 2014 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical consumers and remove the ignition key.

-- Open the left storage compartment in the luggage compartment.

The bracket with the Digital Sound System Control Module -J525- must be removed first.

-- Release and disconnect the connectors from the Digital Sound System Control Module -J525- -2-.

Fig 1: Locating Nuts And Screws -Arrows- On Bracket -1-

Courtesy of AUDI OF AMERICA, LLC

-- Insert the Fiber-Optic Repair Set - Connector Protective CapsVAS6223/9 -1- onto the MOST Bus connector -2-.

Fig 2: Identifying Fiber-Optic Cable Harness Connector And Protective Cap For Cable Connector VAS 6223/9

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts and screws -arrows- on the bracket -1- and remove the Digital Sound System Control Module -J525- -2- with the bracket -1-.

Fig 3: Locating Nuts And Screws -Arrows- On Bracket -1-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the screws -arrows- and remove the Digital Sound System Control Module -J525- -1- from the bracket -2-.

Fig 4: Locating Screws -Arrows- And Remove Digital Sound System Control Module -J525- -1- From Bracket -2

Courtesy of AUDI OF AMERICA, LLC