LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Audi >> 2013 >> TTS Premium Plus, 2D Convertible >> Repair and Diagnosis >> General Information >> Specifications Index >> Common Specifications & Procedures (Roadster) >> Specifications Index
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Specifications Index

SPECIFICATIONS INDEX

System Specification/Procedure
Air Conditioning
Service A/C SYSTEM
Torque FASTENER TIGHTENING SPECIFICATIONS
Axle Nut/Hub Nut
Front 200 Nm +180°
Rear FWD 
200 Nm +180°
Twelve Point Bolt with Ribs: 70 Nm + 90°
Twelve Point Bolt without Ribs: 200 Nm +180°
AWD 
Hex Bolt: 200 Nm +180°
Twelve Point Bolt with Ribs: 70 Nm + 90°
Twelve Point Bolt without Ribs: 200 Nm +180°
Battery BATTERY
Brakes
Bleeding Sequence BRAKE SYSTEM BLEEDING
BRAKE SYSTEM, BLEEDING WITH BRAKE FILLER/BLEEDER UNIT VAS 5234 OR BRAKE FILLER/BLEEDER UNIT SUCTION ADAPTER V.A.G 1869/4
BRAKE SYSTEM, BLEEDING WITHOUT BRAKE FILLER AND BLEEDER TOOL
Disc Brakes TECHNICAL DATA
Torque FASTENER TIGHTENING SPECIFICATIONS
Charging
Generator GENERATOR
Torque FASTENER TIGHTENING SPECIFICATIONS
Drive Belts
Adjustment
2.0L For Engine Code BPY: RIBBED BELT
For Engine Code CCTA & CETA: RIBBED BELT
For Engine Code CDMA: RIBBED BELT
3.2L For Engine Code CBRA: RIBBED BELT
Belt Routing
2.0L Refer to "Installing" in:
For Engine Code BPY: RIBBED BELT
For Engine Code CCTA & CETA: RIBBED BELT
For Engine Code CDMA: RIBBED BELT
3.2L Refer to "Installation" in:
For Engine Code CBRA: RIBBED BELT
Engine Cooling
General Service Specifications Refer to the appropriate FLUID CAPACITY TABLES information.
Radiator Cap Pressure 1.4 to 1.6 bar
Thermostat R & I
2.0L For Engine Code BPY: COOLANT DISTRIBUTION HOUSING WITH MAP CONTROLLED ENGINE COOLING THERMOSTAT
For Engine Code CCTA & CETA: COOLANT THERMOSTAT
For Engine Code CDMA: COOLANT THERMOSTAT WITH HOUSING
3.2L For Engine Code CBRA: COOLANT THERMOSTAT HOUSING
Water Pump R & I
2.0L For Engine Code BPY: COOLANT PUMP
For Engine Code CCTA & CETA: COOLANT PUMP
For Engine Code CDMA: COOLANT PUMP
3.2L For Engine Code CBRA: COOLANT PUMP
Engine Mechanical
2.0L
Compression For Engine Code BPY: COMPRESSION, CHECKING
For Engine Code CCTA & CETA: COMPRESSION, CHECKING
For Engine Code CDMA: COMPRESSION, CHECKING
Oil Pressure For Engine Code BPY: OIL PRESSURE AND OIL PRESSURE SWITCH, CHECKING
For Engine Code CCTA & CETA: OIL PRESSURE, CHECKING
For Engine Code CDMA: OIL PRESSURE, CHECKING
Overhaul For Engine Code BPY: 10 ENGINE ASSEMBLY
For Engine Code CCTA & CETA: ENGINE ASSEMBLY
For Engine Code CDMA: 10 ENGINE ASSEMBLY
Torque For Engine Code BPY: FASTENER TIGHTENING SPECIFICATIONS
For Engine Code CCTA & CETA: FASTENER TIGHTENING SPECIFICATIONS
For Engine Code CDMA: FASTENER TIGHTENING SPECIFICATIONS
3.2L
Compression For Engine Code CBRA: COMPRESSION, CHECKING
Oil Pressure For Engine Code CBRA: OIL PRESSURE AND OIL PRESSURE SWITCH, CHECKING
Overhaul For Engine Code CBRA: 10 ENGINE ASSEMBLY
Torque For Engine Code CBRA: FASTENER TIGHTENING SPECIFICATIONS
Fluid Specifications Refer to the appropriate Maintenance service information.
Engine Oil Pan Drain Plug 30 Nm
Flywheel/Flex Plate Torque 60 Nm + 90°
Fuel System
Pressure Specification
2.0L BPY 
Aprrox. 49 Bar at idle.
Aprrox. 120 Bar under certain operating conditions.
CDMA 
High pressure section (maximum approximately 150 bar) and a low pressure system (approximately 7 bar)
CCTA & CETA 
High pressure section (maximum approximately 150 bar) and a low pressure system (approximately 7 bar)
3.2L Approx: 4.0 Bar
Fuel Pressure Test Procedure
2.0L For Engine Code BPY & CDMA: FUEL PRESSURE AND RESIDUAL PRESSURE BEFORE HIGH PRESSURE PUMP, CHECKING
For Engine Code CCTA & CETA: FUEL PRESSURE AND RESIDUAL PRESSURE BEFORE HIGH PRESSURE PUMP, CHECKING
3.2L FUEL PRESSURE REGULATOR AND RESIDUAL PRESSURE, CHECKING
Ignition
Firing Order & Cylinder Identification FIRING ORDER & CYLINDER IDENTIFICATION
Ignition Wires (Resistance) Coil-On-Plug
Ignition Wires (Routing) Coil-On-Plug
Spark Plug
2.0L Bosch 
06H 905 611
NGK 
06H 905 601 A
3.2l Bosch 
06H 905 611
NGK 
06H 905 601 A
Starting
Starter STARTER OVERVIEW
Torque FASTENER TIGHTENING SPECIFICATIONS
Wheel Alignment
Adjustment Specifications WHEEL ALIGNMENT SPECIFIED VALUES
Torque FASTENER TIGHTENING SPECIFICATIONS
 
Wheel & Tire
Wheel Lug Nut Torque Standard Wheel 
89 Ft. Lbs (120 N.m)
PAX Wheel 
103 Ft.Lbs (140 N.m)