Selector Lever Cable, Bringing Into Basic Setting

Special Tools And Workshop Equipment Required

Vehicle Diagnostic Tester
Pry Lever 80-200
Socket And Key T40031

Procedure

Guided Fault Finding with the Vehicle Diagnostic Tester is completed; all faults have been corrected.

-- Select the following menu items in "Functions/Component selection" "Guided Fault Finding" on the Vehicle Diagnostic Tester:

Drivetrain
0AW transmission
01-OBD-capable systems
02-transmission electronics
02-Transmission electronics, functions
02-Measured values

-- Select driving mode from the list.

-- Compare the following displays:

Measured value driving mode on the Vehicle Diagnostic Tester
Selector lever position
Selector Lever Transmission Range Position Display Unit -Y26- on the shift mechanism
Transmission Range Display -Y6- in the instrument cluster

Conditions:

The displays must match

If The Displays Do Not Match:

-- Adjust the selector lever cable, refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .

If the individual displays cannot be reached by adjusting the selector lever cable:

Selector Lever Cable, Bringing Into Basic Setting:

Fig 1: Identifying Electrical Connector On Transmission By Rotating Twist Lock Counter-Clockwise

Courtesy of AUDI OF AMERICA, LLC

-- Remove the ball socket -1- on the selector lever cable from the selector shaft lever using the Pry Lever 80-200.

NOTE:

Ignore -item 2- and -arrows-.

-- Push the selector lever -A- on the transmission all the way to the back -arrow- until the parking lock locks into place.

Fig 2: Press Transmission Selector Lever Toward The Rear Until The Parking Lock Engages

Courtesy of AUDI OF AMERICA, LLC

When parking lock is engaged, it must not be possible to turn the front wheels.

-- Press the selector shaft lever forward three detents so the transmission is in "D".

-- Make sure the selector lever inside the vehicle is also in "D".

-- Insert the Socket And Key T40031 through the opening -arrow- in the selector mechanism and loosen the bolt on the selector lever cable approximately one turn.

Fig 3: Insert T40031 Through Opening In Selector Mechanism And Loosen Bolt On Selector Lever Cable One Turn

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Only loosen the clamping screw - do not remove it.

The clamping screw is only accessible when the selector lever is in "D".

The selector lever must remain in "D" when the clamping screw is loose.

-- Remove the Socket And Key T40031 from the torque wrench and let the move it through the opening -arrow- in the selector mechanism.

-- Carefully press the selector lever cable ball socket -1- in this position onto the selector shaft lever.

Fig 4: Identifying Electrical Connector On Transmission By Rotating Twist Lock Counter-Clockwise

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Do not bend selector shaft lever when pressing on, otherwise shift mechanism can no longer be adjusted exactly.

Ignore -item 2- and -arrows-.

-- Select 02-measured values in "Guided Fault Finding" 02 transmission electronics on the Vehicle Diagnostic Tester.

-- Select driving mode from the list.

-- Compare the following displays:

Measured value driving mode on the Vehicle Diagnostic Tester
Selector lever position
Selector Lever Transmission Range Position Display Unit -Y26- on the shift mechanism
Transmission Range Display -Y6- in the instrument cluster

Conditions:

The displays must match

-- Carefully move the selector forward and back gently without shifting into another selector lever position. This releases the tension in the selector lever cable.

Fig 5: Insert T40031 Through Opening In Selector Mechanism And Loosen Bolt On Selector Lever Cable One Turn

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the clamping screw in this position with the Socket And Key T40031 without touching the selector lever.

-- Check the selector mechanism, refer to GEARSHIFT MECHANISM, CHECKING .

Tightening Specifications

Refer to OVERVIEW - SELECTOR LEVER CABLE