Overview - Control Module And Hydraulic Unit
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
- ABS Hydraulic Unit -N55- with ABS Control Module -J104-
- Installed location: in the front left engine compartment.
- Refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING .
- The hydraulic control unit consists of ABS Hydraulic Unit -N55- with integrated Brake Pressure Sensor 1 -G201- and the ABS Control Module -J104-.
- Do not disconnect the connector before successfully completing OBD.
- Switch the ignition off before disconnecting the connector.CAUTION:
ABS Hydraulic Unit -N55- and ABS Control Module -J104- must not be disconnected from each other.
- Bracket
- Cannot be removed.
- Connector
- For ABS Control Module -J104-
- Brake Line
- To the brake master cylinder
- Brake Line
- To the brake master cylinder
- Brake Lines
- Hydraulic unit to right front brake caliper
- Hydraulic unit to left front brake caliper
- Hydraulic unit to left rear brake caliper
- Hydraulic unit to right rear brake caliper