MULTIFUNCTION Transmission Range Switch, Adjusting: Notes
Special tools and workshop equipment required
- Gauge - Multi Function Switch: T10173
-- Move the selector lever into "N".
-- Do not bend the selector lever cable.
Adjustment Prerequisites
- The selector lever cable is removed from the gearshift lever.
- The selector shaft is in "N".
- The Multifunction Transmission Range Switch -F125- bolts are loosened.
- The gearshift lever is removed from the gearshift shaft.
Work Sequence:
-- Install the Gauge - Multi Function Switch: T10173 on the selector shaft -2- and turn the multifunction switch -1- just until the Multifunction Transmission Range Switch -F125- locks onto the tab on the connector on the Multifunction Transmission Range Switch -F125-.
-- Use the bolt -3- to secure the Gauge - Multi Function Switch: T10173 to the selector shaft -2-.
-- Tighten the bolts -arrows- to the tightening specification.
-- Remove the Gauge - Multi Function Switch: T10173 .
-- Further installation is performed in the reverse sequence, refer to MULTIFUNCTION TRANSMISSION RANGE SWITCH, REMOVING AND INSTALLING .