Control Position, Programming
Adapting control position and checking headlamp basic setting is necessary if:
- The lower transverse link has been removed and reinstalled or replaced
- The subframe was replaced,
- Installation work has been performed on the level control system sensor,
- The level control system sensor has been replaced,
- The level control system sensor coupling rod threaded connection was loosened at the lower transverse link.
- The Level Control System Control Module -J197- was replaced.
Requirements
- The vehicle must be standing on an even surface.
- The vehicle may not be loaded.
The Programing and Control Position Is Performed Using the Vehicle Diagnostic Tester:
VASPC
Connect Vehicle Diagnostic Tester.
-- Select Guided Functions mode.
-- Select the "34 - Level Control System Control Module" address.
-- Select "J197 - reprogram control position" and follow the instructions on the screen.
ODIS - Offboard Diagnostic Information System
Connect Vehicle Diagnostic Tester.
-- Select Diagnostic operating mode and start diagnostics.
-- Select the Control Module tab.
-- Select the "34 - Level Control System Control Module" address.
-- Select "J197 - reprogram control position" and follow the instructions on the screen.
If the control position was reprogrammed and if the vehicle has lane assist, then it will then be necessary to recalibrate the Camera Control Module -J852-. Refer to DRIVER ASSISTANCE SYSTEMS FRONT CAMERA, CALIBRATING .
Perform the basic setting of the headlamps. Refer to HEADLAMP, ADJUSTING .