Control Module And Hydraulic Unit, Installing: Notes

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Do not remove sealing plugs at new hydraulic unit until the corresponding brake line is about to be installed.

If the sealing plugs are removed too early, brake fluid can escape and unit may not be sufficiently filled or adequately bled.

-- Install In Reverse Order Of Removal.

-- Before installing the bracket for the ABS Hydraulic Unit -N55-, spray the rubber buffers with silicone lubricant D 007 000 A2, which makes the installation easier.

WARNING:

Make sure that the rubber buffers are not pressed out when installing the bracket. After installing the hydraulic unit with the control module, check for a secure fit; otherwise malfunctions may occur.

-- Remove the Brake Pedal Actuator:VAG1869/2 .

-- Bleed the brake system. Refer to BRAKE SYSTEM, BLEEDING .

-- Enter Radio Code.

-- Code the ABS Control Module -J104- using the Vehicle Diagnostic Tester in "Guided Fault Finding".

-- After replacing the ABS Control Module -J104-, an additional basic setting must be performed.