Night Vision System Camera, Removing And Installing: Removing: Notes

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi S8, 2015 Audi A8 Quattro, 2014 Audi S8, 2014 Audi A8 Quattro, and 2013 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the front lock carrier cover, refer to Lock Carrier .

-- Remove the right and left bolts for the front bumper cover.

Fig 1: Identifying Front Bumper Cover Bolts

Courtesy of AUDI OF AMERICA, LLC

-- If installed, remove the left and right air intake connections -arrows-.

Fig 2: Identifying Air Intake Connections

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -1- and remove the bracket -2-.

Fig 3: Identifying Bolt And Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Release the clamp -arrow-, and remove the washer fluid hose -1-.

Fig 4: Identifying And Washer Fluid Hose

Courtesy of AUDI OF AMERICA, LLC

-- Clamp off the washer fluid hose at a suitable location using Hose Clamps - Up To 25mm3094.

-- Remove the horn with the bracket from the front end and set aside, refer to [For engine(s) CDRA,CTUB,CEUA,CGTA,CPNA,CEJA] Horn .

-- Remove the bolts -arrows-.

Fig 5: Identifying Bolts

Courtesy of AUDI OF AMERICA, LLC

-- For the following work the front bumper cover is pulled slightly forward.

-- Remove the Night Vision System Camera -R212- with the retaining plate from the front bumper cover and guide upward. Pay attention that the spray nozzle is not damaged.

-- Disconnect the connector to the Night Vision System Camera -R212-.

-- Remove the bolts -1- through -3- and remove the Night Vision System Camera -R212- from the retaining plate.

Fig 6: Identifying Bolts -1- Through -3- And Remove Night Vision System Camera -R212-

Courtesy of AUDI OF AMERICA, LLC