Night Vision System Control Module, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi S8, 2015 Audi A8 Quattro, 2014 Audi S8, 2014 Audi A8 Quattro, and 2013 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.

The Night Vision System Control Module -J853- is located in the front left footwell.

NOTE:

If replacing the control module, select the "Replace Control Module" function see Vehicle Diagnostic Tester.

-- Loosen the front left seat and with the wires still attached and push rearward, refer to Front Seats .

-- Remove the floor mat.

-- Remove the sill panel, refer to Passenger Compartment Trim .

-- Remove the foot rest, refer to Passenger Compartment Trim .

-- Remove the cover -1- for the emergency release -arrows-.

Fig 1: Removing Parking Lock Emergency Release Cover

Courtesy of AUDI OF AMERICA, LLC

-- Disengage the carpet and push aside, while doing this guide the cover -1- for the emergency release through the opening.

-- Release the clips in the direction of the -arrow-.

Fig 2: Locating Clips

Courtesy of AUDI OF AMERICA, LLC

-- Open cover -1-.

-- Release connectors -1 and 2- and remove from the Night Vision System Control Module -J853- -3-

Fig 3: Identifying Connectors And Night Vision System Control Module -J853- -3-

Courtesy of AUDI OF AMERICA, LLC

First release connector -2- and then -1-.

-- Push the retaining tab in the direction of the -arrow- and remove the Night Vision System Control Module - 853- -3- from the E-box.