Overview - Control Module And Hydraulic Unit
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi S8, 2015 Audi A8 Quattro, 2014 Audi S8, 2014 Audi A8 Quattro, and 2013 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.
ABS Control Module -J104- and ABS Hydraulic Unit -N55-
- Bolt
- 4.5 Nm
- ABS Control Module -J104-
- Information for exchanging control modules, refer to CONTROL MODULE, SEPARATING FROM HYDRAULIC UNIT .
- Control module, replacing, refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING .
- Wiring Harness Connector
- Do not disconnect the connector (47-pin) before successfully completing On Board Diagnostic (OBD).. Turn off the ignition before disconnecting the connector.
- ABS Hydraulic Unit -N55-
- Removing and installing, refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING .CAUTION:
There is a risk of destroying the hydraulic unit.
- The pump motor may not be separated from the ABS Hydraulic Unit -N55-.
- Removing and installing, refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING .
ABS Control Module -J104-
Fig 2: Identifying Pressure Sensor Contact, Pressure Sensor, Seal, Valve Bodies And Pump Motor Contact
- Pressure Sensor
- Do not touch the contacts
- The illustration depends on the model
- Pressure Sensor
- Must not be changed or damaged
- Cannot be replaced
- The illustration depends on the model
- Seal
- Must not be pulled out or raised up
- Cannot be replaced
- Valve Bodies
- Must not be damaged or bent
- Do not use any tools on the valve bodies
- Pump Motor Contact
- Must not be damaged or bent