LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Audi >> 2016 >> S8 Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 537 (Antilock Brake System) >> 45 Antilock Brake System >> Sensors >> Sensor Electronics Control Module, Removing And Installing >> Removing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Sensor Electronics Control Module, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi S8, 2015 Audi A8 Quattro, 2014 Audi S8, 2014 Audi A8 Quattro, and 2013 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the center console support -A-, refer to CENTER CONSOLE .

Fig 1: Center Console -A- And Insulation Mat -B-
GWWA87-10761Courtesy of AUDI OF AMERICA, LLC

-- Remove the rear air distribution housing -C- on the center tunnel, refer to REAR HEATER AND A/C UNIT .

-- Equipment levels with rear A/C unit: free up the wires for the rear A/C sensors and lift the rear A/C unit as far as possible from the center tunnel.

-- Disconnect the connector -3-.

Fig 2: Sensor Electronics Control Module -J849- Tightening Specification
GWWA45-10117Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -1-.

-- Remove the Sensor Electronics Control Module -J849- -2-.