Infrared System, Calibrating: Notes
Special tools and workshop equipment required
- Setting Device Basic Set - VAS6430/1- or Setting Device Basic Set - VAS6430-
- Night Vision Calibration Tool - VAS6430/6-
- Calibration Tool - Linear Laser - VAS6350/3A- (can be used from the Calibration Tool - VAS6350-)
- Vehicle Diagnostic Tester
- Wheel Alignment Computer
NOTE:
- Make sure the Night Vision System Camera - R212- fits correctly in the bracket and the viewing range for the camera is not blocked.
- Make sure the protective window on the Night Vision System Camera - R212- is not chipped. Replace it if necessary. Refer to Infrared System; Night Vision System Camera, Removing and Installing.
- If the vehicle has an adaptive cruise control and night vision system, then the night vision system must be adjusted/calibrated first and after that can the adaptive cruise control be adjusted. -->
- If the -VAS6430/3- is located on the calibration beam of the -VAS6430/1-, it must be removed.