Peripheral Camera System, Calibrating: Notes
- The vehicle must be on a level surface.
NOTE:
The vehicle in the illustration is only a basic outline.
- Roll out the -VAS721001- at the left and right near the vehicle.
- Install the rear and front clamping strip on the -VAS721001-.
- Align the crosshairs -2- to the front axle of the vehicle (center front wheel).
- Align both calibration devices parallel. The vehicle must be located in the center between both calibration devices.
Pay attention to the following measurement requirements:
- Dimension -a- 2000 to 2500 mm ± 5 mm, front and rear the same
- The dimension -b- must be the same on both sides
- The dimension -c- must be the same on both sides
- Set-up the requirement for the vehicle. Refer to Peripheral Camera, Calibrating .