7.3.2 Image Processing Control Module -J851-, Removing and Installing, RHD
NOTE:
If replacing the control module, select the "Replace control module" function for the corresponding control module on the Vehicle Diagnostic Tester
Vehicle diagnostic tester.
Removing
- Remove the left front sill panel. Refer to Body Interior Vehicle Interior Trim Panels; Sill Panel (Removing and Installing.)
- Remove the floor mat.
- Loosen the front passenger seat and push rearward with the wires still attached. Refer to Body Interior; Rep. Gr. 72; Front Seat; Front Seat (Removing and Installing) .
- Disengage the carpet and push aside.
- Remove the nuts -arrows-.
- Remove the bolts -2 and 6- and remove the bracket -5- from the image processing control module.
- Disconnect the connector -4- and antenna wire -3-.
- Remove the image processing control module -1- from the front passenger footwell.
Installing
Install in reverse order of removal.
Tightening Specifications