6.2.2 Retaining Plate for Distance Regulation Control Modules - J428-/-J850-, Removing and Installing

Special tools and workshop equipment required

Removing

Remove the distance regulation control module. Refer to 6.2.1 Distance Regulation Control Modules - J428-/-J850-, Removing and Installing
Place the control module on a soft and clean surface.
Destroy the clips -arrows-.
Remove the retaining plate -2- from the Distance Regulation Control Module - J428-item 1-.

Installing

Install in reverse order of removal and note the following:

Insert the new clips until they engage in the retaining plate.
Left side of the vehicle: the closed clip -1- must be seated on the bracket -2- at the bottom on the inside.
Right side of the vehicle: the closed clip -1- must be seated on the bracket -2- at the bottom on the outside.
Measure the dimension -a- at all stud bolts using the Digital Caliper -VAS6335- and correct if necessary.
- Dimension-a- = 17.6 mm.
- Install the retaining plate with the stud bolts on the control module.
- The stud bolt must be aligned correctly to the clip.
- Push the stud bolt -1- all the way into the clip -2- as shown.