Control Module, Separating From Hydraulic Unit: Procedure
-- Remove the hydraulic control unit. Refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING .
CAUTION:
There is a risk of destroying the hydraulic unit.
- Touch a grounded object (ESD Work Surface:VAS6613 before disconnecting the components.
- Do not touch the connector terminals or electronic components directly.
-- Place the hydraulic unit with the control module on the ESD Work Surface:VAS6613 .
- The control module -2- faces upward and the hydraulic unit -4- with the pump motor and connector -3- faces down.
-- Remove the bolts -1- and dispose of them.
-- Carefully remove the control module vertically upward without tilting.
-- Cover the open hydraulic unit with a lint-free cloth.
-- Check the hydraulic unit sealing surface, and if necessary, clean with mineral spirits and a lint-free cloth.
-- A damaged sealing surface must not be mechanically reworked. A hydraulic unit with a damaged sealing surface must be replaced.
CAUTION:
There is a risk of destroying the hydraulic unit.
- The seal must not be pulled out or raised up. The seal cannot be replaced.