Laser Distance Regulation Control Module -J1122-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the lock carrier cover. Refer to OVERVIEW - BUMPER COVER .

-- Remove the upper air duct. Refer to OVERVIEW - RADIATOR/RADIATOR FAN .

-- Release the clamp on the washer fluid hose connecting piece -1-.

Courtesy of AUDI

-- Remove the washer fluid hose from the washer nozzle -2-.

-- Remove the washer nozzle -2- on the cap -3- all the way forward from the radiator grille and hold it in this position.

-- Push the retaining tabs on the cap -3- apart in direction of -A arrows-.

-- Remove the cap -3- from the washer nozzle -2- in direction of -arrow B-

-- Clean and dry the Laser Distance Regulation Control Module -J1122- -2- near the connector -3-.

Courtesy of AUDI

-- Release and disconnect the connector -3-.

-- Remove the wiring harness bracket -1- from the Laser Distance Regulation Control Module -J1122- -2-.

-- Remove the bolts -arrows-.

-- Remove the Laser Distance Regulation Control Module -J1122- -2- toward the rear from the radiator grille.