Night Vision System Control Module, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Audi RS 6 Avant and 2021 Audi RS 6 Avant. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.

-- Loosen the left front seat and, with the wires still attached, push it toward the rear. Refer to OVERVIEW - FRONT SEAT .

-- Remove the floor mat.

-- Remove the sill panel. Refer to OVERVIEW - SILL PANEL .

-- Remove the footrest. Refer to OVERVIEW - FOOTREST AND CARPET .

-- Disengage the carpet and push it aside.

-- Remove the nuts -arrows- from the bracket -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Release and disconnect the connectors -3- from the Night Vision System Control Module -J853- -1-.

-- Remove the Night Vision System Control Module -J853- -1- with the bracket -2-.

-- Remove the bolts -3-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Night Vision System Control Module -J853- -1- from the bracket -2-.