Rearview Camera -R189-, REMOVING AND INSTALLING

WARNING: This page is about a different car, the 2022 Audi SQ7 and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

The Rearview Camera -R189- is integrated in the Release Button in Rear Lid Handle -E234-. The Rearview Camera -R189- and the Release Button in Rear Lid Handle - E234- cannot be separated. If damaged, the entire Release Button in Rear Lid Handle -E234- must be replaced with the rearview camera.

-- If replacing the control module, select the "Replace control module" function for the corresponding control module using the Vehicle Diagnostic Tester.

-- Remove and install the Release Button in Rear Lid Handle -E234-. Refer to COMPONENT LOCATION OVERVIEW - CONTROLS IN LUGGAGE COMPARTMENT .

After removing and installing the Rearview Camera -R189- the rearview camera system must be calibrated. Refer to REARVIEW CAMERA SYSTEM, CALIBRATING .